Bug-o-systems BEAM BUG III Bedienungsanleitung PDF herunterladen (Seite 9)

916

BEAM RAILS

1. ARR-9114 BEAM RAIL for 14" (350 mm) Beams “Square Cut Only”.

2. ARR-9214 BEAM RAIL for “MITER CUTTING” up to 14" (350 mm)

Beams.

3. ARR-9236 BEAM RAIL for “MITER CUTTING” up to 36" (900 mm)

Beams.

These rails have a swivel magnet bar on one side for easy alignment, and

are fastened by clamps on the opposite ange of the beam.

OPERATING INSTRUCTIONS

4. Plug the Power Cord (W) into an appropriate power source. Pilot Light (Y)

will glow when power is on.

5. Open Torch Valves (EE) throw Quick Acting Manifold (S) lever “Down”

to “Open” position to set fuel gas and oxygen regulators. See Chart (M)

on the side of machine for tip size and pressure vs. thickness.

6. Close Torch Valves (EE), reopen slightly and light - adjust preheat

ame. Turn off preheat with Quick Acting Manifold (S).

7. To make a square cut: (Ref. Fig. 4, 5 & 6).

A. Set Rack (G) in holes on Flange Rail (B) which corresponds to

the thickness of the ange you are cutting. Run BEAM BUG III

out beyond ange and swing torch so tip faces ange.

B. Run Flange Rail (B) downwards until Torch Tip (DD) is slightly

below bottom of ange and stop (use maximum speed).

C. Switch on gases using the Quick Acting Manifold (S) light

Torch (BB), and set cutting speed. When preheat is adequate,

open Cutting Oxygen Valve (FF) [bat handle on torch] and start

vertical travel - adjust speed to suit.

NOTE: As cut comes close to web slow down vertical travel to

insure adequate penetration of web - once past web, increase

travel speed to optimum.

D. When cut has reached the top of ange, turn off preheat gases

using the Quick Acting Manifold (S) and Cutting Oxygen Valve

(FF), limit switch will stop travel.

SQUARE CUTS

Figure 3

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 22 23

Keine Kommentare

Bug-o-systems BEAM BUG III Bedienungsanleitung Seite 9